Kingston Technology Corp. KSM56R46BD8PMI-48MBI 48GB DDR5-5600 CL46 2Rx8 Registered server RAM
- 48 GB
- DDR5 5600
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
4GB DDR3L 1600 ECC UDIMM with CL11 latency and 1.35V low-voltage operation for server upgrades
This A-Tech module is a 4GB DDR3L 1600 ECC unbuffered DIMM built for server and workstation systems. It runs at 1.35V with CL11 latency and uses a 1Rx8 configuration on a 240-pin PCB. The stick is a direct replacement for several Hynix part numbers including HMT451E7AFR8A-PB and HMT451U7BFR8A-PB.
It fits boards that accept DDR3L 1600 ECC unbuffered memory at 1.35V and will not work in slots that require registered RDIMMs or a different voltage. Systems needing higher capacity per module or a different pin count should look elsewhere.
The single specification that determines whether this is the right part is the 1.35V DDR3L operating voltage. If your platform specifies 1.5V DDR3 or requires registered memory this module will not function.
Measured against everything we stock in ECC Server RAM, at today’s prices. Recalculated every night.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | A-Tech |
| Total capacity | 4 GB |
| Performance | |
| Rated speed | DDR3L 1600 (PC3L 12800) |
| Processor | |
| Chipset | Major Brand Chipset |
| Memory | |
| CAS latency | CL11 |
| ECC support | Yes |
| Buffer type | Unbuffered |
| Memory rank | 1Rx8 |
| Power | |
| Rated voltage | 1.35 V |
The stick operates at 1.35 V, which is the DDR3L low-voltage spec; lower voltage typically means less heat than 1.5 V DDR3 under the same sustained workload.
You need a 240-pin DDR3 slot that supports ECC unbuffered memory and can run at 1.35 V; the board must also accept 1Rx8 modules at 1600 MHz.
The module runs at 1600 MHz CL11; if slower DDR3 is present the system will downclock all sticks to the lowest common speed and latency.
More in ECC Server RAM
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?