Kingston Technology Corp. KSM56R46BD8PMI-48MBI 48GB DDR5-5600 CL46 2Rx8 Registered server RAM
- 48 GB
- DDR5 5600
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
4GB DDR4 2133 ECC UDIMM module with CL15 latency and 1.2V operation for compatible IBM-Lenovo servers
This 4 GB DDR4 2133 MHz ECC unbuffered DIMM uses a single-rank 1Rx8 organisation and runs at 1.20 V with CL15 latency. It is built with major-brand chips and carries a 288-pin form factor for server and workstation platforms. The module is validated as a direct replacement for IBM-Lenovo part numbers 46W0808, 46W0809, 4X70G88315 and 4X70K14183.
This module fits systems that accept DDR4 ECC UDIMMs at 2133 MHz and require only 4 GB per slot. It is not for builds that need registered or load-reduced memory, higher densities per module, faster DDR4 speeds or non-ECC consumer DIMMs. Buyers whose platforms demand RDIMM, LRDIMM or capacities above 4 GB should look elsewhere.
ECC circuitry corrects single-bit errors on the fly, preventing data corruption during long-running compute or virtualisation tasks. The 1.20 V standard voltage keeps power draw predictable when all slots are populated. Unbuffered topology adds minimal latency, so sustained bandwidth remains consistent without the registration delay of RDIMMs.
Measured against everything we stock in ECC Server RAM, at today’s prices. Recalculated every night.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | A-Tech |
| Total capacity | 4 GB |
| Performance | |
| Rated speed | DDR4 2133 (PC4 17000) |
| Processor | |
| Chipset | Major Brand Chipset |
| Memory | |
| CAS latency | CL15 |
| ECC support | Yes |
| Buffer type | Unbuffered |
| Memory rank | 1Rx8 |
| Power | |
| Rated voltage | 1.2 V |
It fits a standard DDR4 UDIMM slot on a server or workstation board that accepts 1.20V ECC unbuffered memory at 2133 MHz.
Yes, it will operate at the common 2133 MHz speed and 1.20V voltage, though the memory controller will use the slowest timing among installed modules.
Check the BIOS memory information or run a hardware utility such as CPU-Z; both should show 2133 MHz, 4 GB capacity, and ECC enabled.
More in ECC Server RAM
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?