Kingston Technology Corp. KSM56R46BD8PMI-48MBI 48GB DDR5-5600 CL46 2Rx8 Registered server RAM
- 48 GB
- DDR5 5600
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
An 8 GB DDR3L registered ECC DIMM running at 1333 MHz with 1.35 V low voltage for server workloads
This 8GB DDR3L 1333MHz ECC registered DIMM is built for servers and workstations that require error-correcting memory. It replaces the Samsung M392B1G70BH0-YH9 module with a compatible A-Tech alternative. The single-rank 1Rx4 design uses Samsung chipset components. It fits 240-pin DDR3 DIMM slots in supported enterprise platforms.
Running at 1.35V, this DDR3L module draws less power and generates less heat than standard 1.5V DDR3 at the same 1333MHz speed. The registered buffer reduces electrical load on the memory controller, aiding stability in multi-DIMM configurations. CL9 latency delivers predictable timing for typical server workloads. No active cooling is required on the module itself.
This module suits administrators adding capacity to compatible DDR3L platforms or replacing failed 4GB or non-ECC sticks. The jump is worthwhile when ECC protection and registered signalling are mandatory for data integrity. It will not work in systems limited to unbuffered UDIMMs or those requiring 1.5V-only memory. Verify your platform's qualified vendor list before purchasing.
Measured against everything we stock in ECC Server RAM, at today’s prices. Recalculated every night.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | A-Tech |
| Product line | Compatible Replacement for Samsung |
| Model name | M392B1G70BH0-YH9 |
| Total capacity | 8 GB |
| Performance | |
| Rated speed | DDR3L 1333 (PC3L 10600) |
| Processor | |
| Chipset | Samsung Chipset |
| Memory | |
| CAS latency | CL9 |
| ECC support | Yes |
| Buffer type | Registered |
| Memory rank | 1Rx4 |
| Power | |
| Rated voltage | 1.35 V |
Align the notch on the module with the key in the 240-pin slot, press firmly until both retention clips click, then verify in BIOS that the server registers the full 8GB at 1.35V — the step most often missed is confirming the registered ECC mode is enabled in firmware.
No routine maintenance is required; the module either passes POST or it does not, so replacement only occurs if a memory test reports uncorrectable ECC errors or the system fails to recognise the 8GB capacity.
The 1333MHz bus speed and CL9 latency set the throughput ceiling; under continuous load the memory controller hits that bandwidth limit before the 1.35V low-voltage thermal envelope becomes a constraint.
More in ECC Server RAM
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?