Silverstone CPS05-RE SFF-8643 36-Pin to SATA 7-Pin x4 Sideband Cable 600mm
- SAS ports: 4
- SAS / SATA
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 10 metre passive twinaxial cable with SFP+ connectors at both ends for direct 10G links
The Axiom J9286B-AX is a 10 Gb SFP+ direct-attach copper cable built for short-reach links between switches, servers or storage arrays. It targets network engineers and system integrators who need a low-latency, cost-effective interconnect for 10 Gigabit Ethernet or compatible SAS environments.
As a passive twinax assembly the cable draws no power and adds no active components to the signal path. At the full 33 ft (10 m) length insertion loss is higher than on shorter passive DACs, so sustained throughput depends on the host ports’ equalisation capability and the overall link budget.
Verify that both ends accept SFP+ passive copper modules and that the port firmware supports third-party DACs; some vendors lock ports to branded optics. Confirm the switch or HBA can negotiate 10 Gb speeds over a 10 m passive reach and that the physical SFP+ cages are not blocked by adjacent modules or chassis rails.
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Axiom |
| Product type | Twinaxial |
| Connectivity | |
| Cable category | Twinaxial |
| Ports & slots | |
| First connector | 1 x SFP+ Network |
| Second connector | 1 x SFP+ - Network 1 x SFP+ Network |
The passive design uses no active electronics, so the cable itself produces no measurable heat during all-day operation.
You need two SFP+ network ports — one at each end — that accept a passive twinax cable with SFP+ connectors.
The cable is built for Aruba 5406 zl compatibility and plugs into standard SFP+ slots; older SFP-only ports cannot accept the SFP+ form factor.
More in SAS, SCSI, InfiniBand & MCIO Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?