Axiom QSFP-100G-LR-JNP-AX 100GBASE-LR QSFP28 SFP transceiver
A QSFP28 transceiver for 100GBASE-LR links over single-mode fiber up to 10km at 1310nm
- QSFP28 form-factor fits 100G ports directly
- 100GBASE-LR interface reaches 10 km on single-mode fiber
- LC duplex connector uses 1310 nm wavelength for reliable links
- Digital Optical Monitoring gives real-time link health visibility
- Operates from 0 °C to 70 °C for standard data-centre environments
100GBASE-LR QSFP28 transceiver
This Axiom QSFP28 module provides a 100 Gbps single-mode fiber link up to 10 km. It is built for network engineers deploying long-reach connections in Juniper routing and switching platforms.
Replaces OEM LR optics in Juniper gear
The module is pre-coded for Juniper compatibility and meets MSA standards, so it fits directly into existing QSFP28 ports. The upgrade is worthwhile when an operator needs a 10 km reach at 1310 nm without purchasing vendor-branded optics.
Hot-pluggable LC duplex installation
Installation follows standard QSFP28 hot-swap procedure into an LC duplex patch panel. The main risk is inserting the transceiver into a multimode port or exceeding the 0 °C to 70 °C operating range, which will cause link failure.
How it compares
Measured against everything we stock in SFP & SFP+ Transceiver Modules, at today’s prices. Recalculated every night.
- Price $565.99
- Pricier than about 85% of the 1,470 comparable items (median $138.49).
New to this? Buying networking gear with crypto — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Does this QSFP28 transceiver fit a standard LC duplex patch panel?
Yes, it uses an LC duplex connector designed for G652 single-mode fiber, so it plugs directly into any standard LC duplex bulkhead or patch panel.
What is the correct insertion procedure for the QSFP28 module, and what step is often missed?
Slide the module into the switch port until the latch clicks, then remove the dust caps and insert the LC duplex cables; the step often missed is removing the dust caps before cabling.
When should the 1310nm optics be cleaned or the module replaced?
Clean the LC ferrules with a single-mode fiber cleaner whenever signal loss rises or DOM alarms appear; replace the module if errors persist after cleaning or if it exceeds the 0°C to 70°C operating range.
More in SFP & SFP+ Transceiver Modules
Similar items
STARTECH QSFP40GSR4ST 40GBASE-SR4 SFP transceiver
- Transceiver
- IEEE 802.3ba 40GBAS…
HPE JD089B Gigabit Ethernet SFP Transceiver 1000Base-T RJ-45
- Transceiver
- HCRP, SPP
AddOn GLC-T-AO-10PK 10-pack 1000Base-TX SFP transceiver
- RJ-45
- 1 x RJ45
STARTECH MASFP10GBLR SFP+ transceiver 10GBASE-LR 10km 1310nm LC
- Transceiver
- IEEE 802.3ae 10 Gbi…
AddOn QSFP-40G-SR4-S-AO SFP transceiver 40GBase-SR4
- Cisco
- Transceiver





