DELL 451-BBUN 62WHr 4-Cell laptop battery
- Lithium-Ion
- Notebook
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 11.55 V, 90 Wh lithium-ion replacement battery for Siemens Simatic programmer CNC systems 31CP8, 49 and 64-2
This new lithium-ion battery matches the SP307 and 31CP8/49/64-2 part numbers for Siemens Simatic programmer CNC systems. It delivers 11.55 volts and a 90Wh, 7800mAh capacity in a black housing. The pack is built to restore mobile power to the original industrial controller. It is not for users who need a different voltage or connector layout.
The unit replaces the factory battery carrying part numbers SP307 and 31CP8/49/64-2. The change is worth it when the existing cell no longer holds enough charge for a full shift or shows swelling. No other part numbers or chemistries are supported by this model. It is not for technicians servicing non-Simatic hardware or newer controller revisions with different pinouts.
Lithium-ion chemistry maintains the rated voltage across the 90Wh capacity without the sharp sag seen in aged packs. The 7800mAh rating reflects sustained delivery rather than a brief peak. Performance stays consistent until the protection circuit cuts off at the safe lower limit. It is not for applications that demand hot-swap capability or redundant cell arrays.
Measured against everything we stock in Laptop Chargers & Batteries, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | SP307 |
| Model name | SP307 |
| Part number | 31CP8/49/64-2 |
| Product color | Black |
| Product type | Battery |
| Power | |
| Battery type | Lithium-Ion |
| Battery voltage rating | 11.55 V |
| Battery capacity | 90 Wh/7800 mAh |
| Compatibility | |
| Compatible with | For Siemens Simatic Programmer CNC System |
This battery replaces part numbers SP307 and 31CP8/49/64-2 for the Siemens Simatic Programmer CNC System.
Power off the CNC system, open the battery compartment, disconnect the old pack, connect the new SP307 matching the polarity, then secure the cover before powering on.
Replace the pack when the CNC system loses date, time or program memory after power-off, showing the 11.55V cell no longer holds sufficient charge.
More in Laptop Chargers & Batteries
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?