Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Original 203 dpi thermal printhead for SATO CL408, CL408E, MR400E and LM408E barcode printers, supplied new in original packaging
This new original printhead carries part number GH000741A and is built for SATO CL408, CL408E, MR400E and LM408E thermal barcode label printers. It delivers 203 dpi resolution for crisp barcodes and text. The unit ships in its original package and is tested before dispatch. Buyers needing a different resolution or a non-SATO model should look elsewhere.
The printhead runs at the standard 203 dpi density used by the listed SATO models, producing consistent heat for reliable label output. Each item is 100 percent tested before shipping to confirm even heating across the full width. No additional cooling or power specifications are provided by the supplier. Users requiring higher throughput speeds may find the standard thermal cycle limiting.
During extended print runs the head maintains the rated 203 dpi quality without degradation, as verified by the pre-shipment test. The supplier notes technical support is available within 24 hours if issues arise. Continuous heavy-duty cycles beyond typical label batches are not characterised in the data. Customers planning non-stop industrial workloads should verify suitability independently.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product category | Adapters and Batteries |
Power off the printer, open the printhead latch, remove the old head, align the new GH000741A connector, close the latch firmly, then run a calibration test — skipping calibration causes misaligned labels.
Clean the 203dpi heating elements with isopropyl alcohol and a lint-free swab every roll change; replace the printhead when print quality degrades despite cleaning.
The 203dpi thermal elements overheat first, triggering a protective pause until the printhead cools below its operating threshold.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?