SAMA Q70-BKWAYNO3-G 360mm liquid cooler with 2.8" LCD display
- Intel&AMD
- AMD:AM5/AM4
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Compression fittings for 16 mm OD rigid tubing with G1/4 threads, supplied as a four-piece value pack
These Bitspower compression fittings connect rigid tubing with a 16mm outer diameter using standard G1/4 threads. The four-piece pack is built from high-quality brass with a Black Sparkle finish. They are designed for multi-link extension runs in custom liquid-cooling loops. RoHS compliance is confirmed by the manufacturer.
As passive brass components the fittings add no heat, noise or electrical draw to the system. Their only thermal role is to maintain a leak-free seal so coolant can transfer heat from blocks to radiators. Correct assembly ensures the joint stays secure under normal loop pressure.
The multi-link design replaces single straight fittings when you need to join several tubing segments in a straight line or staggered layout. It is worth the switch if your build requires extended rigid-tube runs with fewer potential leak points. Builders who only need simple point-to-point connections will not benefit from the extra length.
Measured against everything we stock in Liquid Cooling & AIO Coolers, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | Fittings |
Slide the compression nut and olive onto the tube, push the tube fully into the fitting body until it seats, then tighten the nut by hand plus a quarter turn with a wrench; the step most often missed is confirming the tube is fully bottomed out before tightening.
Inspect the O-rings annually for hardening or flattening; if a seal weeps, depressurise the loop, remove the fitting, replace the O-ring with a compatible G1/4" size, and reassemble.
The EPDM O-rings typically reach their temperature ceiling before the brass body, so prolonged coolant temperatures above their rated range will cause seal degradation and minor weeping first.
More in Liquid Cooling & AIO Coolers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?