RCA VHB6111N 100 ft RG-6 coaxial rf cable black
- Digital RG6 Coaxial…
- Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
100-foot 50-ohm coaxial cable with N-Male connectors and 6 dB loss per 100 feet for low-loss signal booster runs
The Bolton Technical Bolton400 is a 100-foot coaxial cable built for cellular boosters, Wi-Fi repeaters and any 50-ohm RF installation. It carries signal between outdoor antennas and indoor amplifiers with minimal attenuation. The run length suits whole-home or light-commercial deployments where the amplifier sits far from the donor antenna. New condition means the jacket and connectors arrive undamaged.
Attenuation is rated at 6 dB over the full 100-foot length, so the signal drop is predictable when you plan link budgets. The 50-ohm impedance matches standard cellular and two-way radio gear without adapters. N-Male connectors on both ends mate directly to most booster kits and commercial antennas. CL3 rating confirms the jacket meets in-wall fire codes for permanent routing.
Patented triple shielding and an insulated centre conductor suppress outside interference and keep loss at the rated 6 dB figure. The black polyethylene jacket withstands UV exposure for outdoor segments and meets 300-volt CL3 requirements for riser or plenum spaces. Lifetime technical support is included for installation questions.
Measured against everything we stock in Coaxial RF & Antenna Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
At this length you can expect roughly 6 dB of attenuation, which is considered low for 50 ohm coax and keeps signal degradation minimal across the run.
CL3 rating allows in-wall and commercial building installations, and the 300 volt rating means it meets safety requirements for those environments.
Both ends terminate in N Male connectors, so they mate directly with any standard N Female port on boosters, antennas or repeaters.
More in Coaxial RF & Antenna Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?