Bolton Technical M12 A-Code 8-pin Female to Flying Leads Cable 10m
M12 A-Code 8-pin female connector to flying leads cable, 10 m length with waterproof PVC overmould and shockproof locking
- Reliable signal transmission for industrial sensors and actuators
- Secure M12 A-code 8-pin female connector with shockproof lock
- Waterproof PVC overmould protects against moisture and debris
- 10 m / 33 ft cable length suits extended runs
- Open flying leads allow direct termination to fieldbus modules
Industrial Sensor Connectivity
The Bolton Technical M12 A-Code cable provides an 8-pin female connector to flying leads for industrial sensor and actuator installations. It carries signals for IO Link fieldbus modules and factory automation equipment over a 10m run. The waterproof PVC overmould and threaded lock suit harsh environments. Buyers needing a pre-terminated male plug or a different pin count cannot use this item.
Replaces Damaged Field Wiring
This assembly replaces a failed sensor cable or upgrades a temporary flying-lead splice to a sealed, shielded connection. The jump is worth it when machine downtime costs exceed the cable price and a 33ft reach matches the routing path. Installations requiring shorter or longer runs must specify a custom length before ordering.
M12 A-Code Physical Limits
The A-coded 8-pin interface defines the keying and signal arrangement; it does not carry high-power loads or multi-gigabit Ethernet. Shielding reduces noise on the 10m span, yet voltage drop and signal timing depend on the connected device and cable resistance. Users must verify their module pin-out matches the open leads before wiring.
How it compares
Measured against everything we stock in 2-in-1 Device Accessories, at today’s prices. Recalculated every night.
- Price $56.99
- Typical for this category: the median of 6,330 items is $55.99.
New to this? Buying a laptop with crypto, start to finish — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
What diameter panel cut-out does the M12 A-Code 8-pin female connector need for bulkhead mounting?
The connector uses a standard M12 thread, so a 12 mm clearance hole is required for panel mounting.
Which wire colour matches which pin when terminating the flying leads on this 10 m cable?
Strip the PVC jacket, then match each lead to the pin-out printed on the connector body — pin 1 to pin 8 — before crimping or soldering.
How often should the waterproof overmould and shield be inspected on a 10 m industrial run?
Check the overmould and shield integrity every 12 months or after any severe vibration event to maintain ingress protection.
More in 2-in-1 Device Accessories





