Kingston Technology Corp. KSM56R46BD8PMI-48MBI 48GB DDR5-5600 CL46 2Rx8 Registered server RAM
- 48 GB
- DDR5 5600
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
16 GB DDR4-2400 ECC UDIMM with CL15 latency, 1.2 V operation and 2Rx8 organisation for Dell-compatible servers
This Brute Networks module is a 16 GB DDR4-2400 ECC UDIMM built to match Dell part number CX1KM. It runs at 1.20 V with a CAS latency of CL15 and uses a 2Rx8 organisation. Major-brand Samsung, SK Hynix or Micron chips are used throughout. The stick is validated for Dell systems that accept unbuffered ECC memory.
Replacing standard non-ECC DIMMs with this module adds single-bit error correction for data integrity in server workloads. Moving up from 8 GB sticks doubles capacity per slot without changing voltage or speed. The jump is worth it when the platform supports ECC UDIMMs and the workload demands error detection at 2400 MT/s.
The module plugs directly into any Dell platform that lists CX1KM as a supported part and provides UDIMM slots wired for 1.20 V DDR4-2400. It frees budget compared with OEM-labelled modules while keeping the same chip suppliers and electrical specifications. Systems requiring registered or load-reduced DIMMs cannot use this unbuffered design.
Measured against everything we stock in ECC Server RAM, at today’s prices. Recalculated every night.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Dell |
| Total capacity | 16 GB |
| Performance | |
| Rated speed | DDR4 2400 (PC4 19200) |
| Processor | |
| Chipset | Major Brand Chipset |
| Memory | |
| CAS latency | CL15 |
| ECC support | Yes |
| Buffer type | Unregistered |
| Power | |
| Rated voltage | 1.2 V |
Yes, this is a standard DDR4 UDIMM that fits any desktop or server board with a 288-pin DDR4 DIMM socket running at 1.2V.
Align the notch with the slot key, press straight down until both retention clips click, then verify in BIOS that 16GB at 2400MHz CL15 is detected with ECC enabled.
The modules are 100% tested and carry a lifetime warranty; under normal server workloads no replacement is expected, but Brute Networks will swap any defective stick at no cost.
More in ECC Server RAM
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?