Tripp Lite B119-004-UHD 4-Port HDMI Switch 4K 60 Hz Remote
- 4-Port UHD
- HDMI Switchers
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A DVI switch routes two sources to one display at up to 2560 x 1600 resolution and switches in about two seconds with EDID memory
The BUCIER switch connects two DVI sources to a single DVI display. Both inputs and the output are HDMI-compatible through passive adapters. Switching occurs in roughly two seconds thanks to stored EDID data on each port. The unit remembers the last active input after a power loss.
This switch suits anyone who wants to toggle between two computers, a laptop and a DVR, or similar DVI devices on one monitor. It does not support Dual-Link DVI signals, so builders who need 2560 x 1600 resolution must look elsewhere. The 0.522 kg weight makes it easy to place on a desk or rack shelf.
The specification lists a ceiling of 1600 vertical pixels for DVI signals, explicitly ruling out 2560 x 1600. If your sources and monitor operate at or below that limit the switch will pass the signal without configuration. Higher-resolution workflows require a different solution.
Measured against everything we stock in HDMI & AV Selector Switches, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | BUCIER |
| Part number | GuangDa |
| Product type | DVI |
| Ports & slots | |
| Port count | 2 |
| Input ports | 2 |
| Size & build | |
| Product weight | 0.522 kg |
The unit weighs 0.522 kg and operates without an external power supply, so it sits on a desk or shelf and only needs three DVI cables.
Plug each source into the two input ports, connect the display to the single output port, then press the front button to select the active source.
The switch stores EDID data internally and remembers the last selected input after power loss, so no firmware updates or manual EDID resets are required.
More in HDMI & AV Selector Switches
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?