Total Micro Technologies W2F74AA-TM 150W power adapter
- Others
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Adjustable step-down module converts 3 V–35 V input to 1.25 V–35 V at up to 3 A with 92 % efficiency, supplied as a pair
This pack contains two LM2596S-based step-down modules that accept a DC input from 3V to 35V and provide a continuously adjustable output from 1.25V to 35V at up to 3A. Each board measures 43 by 21 by 14mm and uses a 36u thickened PCB with a high-Q power inductor, Sanyo solid-state capacitors and an LED indicator. The factory preset is approximately 18V, adjustable counterclockwise roughly 1V per turn.
Makers who need a compact, adjustable buck regulator for Arduino, Raspberry Pi or sensor projects will appreciate the solder and pin-header connection options. Designs requiring boost or buck-boost operation, isolated outputs, or sustained currents above 2.5A without added heatsinking should look elsewhere. The modules operate from -45 to +85 degrees Celsius with a maximum efficiency of 92 percent and output ripple below 30mV.
The single specification that decides fit is the 3A peak current rating, with a recommended continuous limit of 2.5A and a heatsink advised above 2A or 10W output. Input voltage must exceed the desired output by at least 1.5V, and the switching frequency is fixed at 65KHz. Reverse polarity will damage the module, so verify wiring before applying power.
Measured against everything we stock in AC Adapters & Power Bricks, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Maxmoral |
| Model name | LM2596-3A-2 |
| Part number | LM2596-3A-2 |
| Product color | Black |
| Size & build | |
| Product weight | 1.58 oz |
You need a DC source between 3 V and 35 V that is at least 1.5 V higher than your desired output; the module cannot boost voltage.
The supplier recommends staying within 2.5 A for long-term use and adding a heat sink whenever the output exceeds 2 A or 10 W.
Measure the output with a multimeter; the factory default is approximately 18 V and each full counter-clockwise turn of the potentiometer drops the voltage by roughly 1 V.
More in AC Adapters & Power Bricks
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?