Tripp Lite U026-016 USB 2.0 Active Extension Cable 16 ft
- USB A to USB A
- USB 2.0
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects a motherboard USB 3.1 front-panel header to a panel-mounted USB-C female port using a 40 cm cable
This 40 cm cable converts a motherboard USB 3.1 front-panel header into a panel-mounted USB-C female port. It suits builders adding a modern front-panel Type-C connection to cases that lack one. The UC-037 is not for systems without a USB 3.1 header or for users needing an internal Type-A port instead.
The USB 3.1 front-panel header uses the USB 3.0 pin set plus additional signals and requires a different header than USB 3.0. No official header specification had been released at the time of design, so compatibility depends on motherboard implementation. Early boards such as the ASUS ROG Maximus IX Formula and Strix Z270I/Z270G were among the first to provide this header.
A Type-C female connector with integrated mounting screw secures the port to a chassis cut-out for a flush finish. The 40 cm length reaches front-panel headers on typical ATX and micro-ATX boards without strain. The cable is not for rear I/O expansion or for extending an existing front-panel Type-C port.
Measured against everything we stock in USB Cords & Extension Cables, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Ports & slots | |
|---|---|
| Connection type | Lighting Connector to USB A |
The 40 cm length fits most mid-tower cases running from the motherboard header to a front-panel cut-out; choose it when the header is within that reach.
The header uses the USB 3.0 pin set plus extra pins, so real-world throughput matches USB 3.0 rates until the motherboard firmware fully enables the 3.1 specification.
The header follows the early 3.1 pin layout found on boards such as the ASUS ROG Maximus IX Formula and STRIX Z270I or Z270G; it is not the older USB 3.0 header.
More in USB Cords & Extension Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?