Lian Li UNI Fan TL LCD Wireless 140mm Reverse Blade case fan 14RTLLCD1W1B
- 140 mm
- Fluid Dynamic
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Three black Y-cables let two 4-pin PWM fans share one motherboard header with simultaneous speed control and RPM monitoring
This set provides three Y-type splitter cables that let two 4-pin PWM fans run from a single motherboard header. Both fans receive the same PWM signal so their speeds stay synchronised, while the RPM signal from one fan is reported back to the board for monitoring. The black sleeving and connectors keep cable runs looking clean in chromax-themed builds.
When a motherboard lacks enough fan headers for every cooler or case fan, these splitters remove the need to leave fans unplugged or running at fixed voltage. Daisy-chaining multiple cables can extend control to more than two fans per header, provided the combined power draw stays within the header's 9.6 or 12W limit. Builders who need independent speed curves for each fan cannot use this passive splitter.
Each cable splits one female 4-pin connector into two male 4-pin connectors that also accept 3-pin fans, though PWM control only works with 4-pin models. The adapters work with CPU coolers, case fans, mining rig arrays or fan controllers such as the NA-FC1. No extra software or drivers are required — just plug into an existing header and route the sleeved leads to the fans.
Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | Case Fan |
Yes, each female connector accepts both 3-pin and 4-pin fan plugs, but PWM speed control only works with 4-pin PWM fans.
Connect the single female end to the header and plug two fans into the male ends, then verify the combined fan draw stays within the 9.6 W or 12 W limit stated in your motherboard manual.
Yes, multiple cables can be daisy-chained, but the total power draw of all connected fans must not exceed the 9.6 W or 12 W header rating from your motherboard manual.
More in PC Cooling Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?