Darkside Computer Modding 3-Pin Triple Push-Pull Radiator Fan Power Y-Cable Splitter Jet Black 50cm
Connects six 3-pin fans in push-pull on dual radiators to a single 3-pin power source, pre-sleeved and 50 cm long
- Cable length1.6 ft (0.49 m)
- Connects six 3-pin fans in push-pull on dual radiators to one 3-pin header
- Pre-sleeved cable keeps wiring tidy inside triple-radiator builds
- 50 cm length spans large cases without excess slack
- Single power source simplifies fan-controller management
- Total fan wattage must stay within the power source rating
Push-Pull Radiator Fan Splitter
This 3-pin Y-cable connects six fans in a push-pull arrangement on dual radiators to a single power source such as a fan controller. It is built for custom liquid-cooling loops that use triple radiators and need tidy power distribution.
Pre-Sleeved 50 cm Cable
The assembly measures approximately 50 cm in total length and comes pre-sleeved for a clean look inside the case. Each branch plugs directly into 3-pin fan headers, so installation follows standard routing paths without adapters.
Wattage Limit Awareness
Users must ensure the combined draw of all six fans stays within the rating of the chosen power source. The splitter itself adds no active regulation, so thermal and acoustic results depend entirely on the attached fans and controller settings.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $8.99
- Cheaper than about 90% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Size & build | |
|---|---|
| Cable length | 1.6 ft (0.49 m) |
Questions about this item
What does the 3-pin connector limit on this splitter?
The 3-pin connector provides power and tachometer signal only, so fan speed is controlled by voltage regulation rather than PWM duty cycles.
What clearance does the 50 cm cable need inside a triple-radiator build?
The 50 cm pre-sleeved cable is optimised for triple radiators and requires enough routing space to reach six fans in a push-pull layout without tension.
How do you install the splitter without overloading the header?
Connect all six 3-pin fans to the splitter, plug the single 3-pin lead into the fan controller, then verify the combined fan wattage stays within the header’s rated limit.
More in Internal PSU & Riser Cables
Similar items
Ruth's sister 1.2m internal power cable with dual USB and audio
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





