Apple MD565LL/A 60W MagSafe 2 Power Adapter
- AC Power
- 60 W, Input: 100-24…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pre-sleeved ATX and PCI-E wires with factory-crimped female pins on both ends, 45 cm long in graphite metallic, simplify custom power-cable builds
The Darkside DS-0656 is a pre-sleeved ATX and PCI-E wire with female terminals on both ends. It removes the need to sleeve or crimp individual conductors when assembling custom power cables. The graphite metallic finish suits colour-coordinated builds. It is sold as a single 45 cm length for modular cable projects.
This wire replaces the raw sleeving, loose terminals and hand-crimping steps normally required for custom ATX cables. The jump is worth it when a builder wants consistent pin placement and uniform colour without investing in crimp tools or learning termination technique. It also saves time when re-pinning existing modular cables for a new colour scheme.
Each end pushes into standard ATX connector housings until the terminal latches. A Billy Brown extraction tool is recommended if a wire is seated in the wrong position, as the retention tabs are difficult to release by hand. No soldering or heat-shrink is required, but builders must verify pin-out compatibility with their specific power supply before seating the terminals.
Measured against everything we stock in Other Adapters & Couplers, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Darkside |
| Model name | 712190092566 |
| Part number | DS-0656 |
The DS-0656 is a 17.5 inch (45 cm) female-to-female pre-sleeved wire with standard ATX pins crimped on both ends, ready for ATX and PCI-E connector housings.
A Billy Brown Tool is recommended to release and remove an incorrectly seated ATX pin from the connector housing without damaging the crimp or sleeve.
The wire arrives pre-sleeved in graphite metallic; the sleeving is fixed over the crimped pins, so it does not require re-sleeving unless the sleeve itself is physically cut or abraded during installation.
More in Other Adapters & Couplers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?