Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement 203 dpi thermal printhead for Datamax H-4212 barcode label printers
The Datamax H-4212 printhead is a direct replacement component for 203dpi thermal barcode label printers. It restores print capability when the original head reaches end of life. Buyers needing higher resolution output or a different printer interface cannot use this part.
Supplied as a brand new original unit under part number PHD20-2240-01, the printhead arrives in single-piece packaging. Installation follows the printer service procedure, seating the head into the carriage and locking it onto the flex cable and mounting brackets. No adapter cables or firmware updates are required.
The head uses resistive heating elements to create 203 dots per inch on thermal media. Normal use generates heat only at the element line, with no active cooling fan attached. Power draw matches the printer's original specification, and acoustic output is limited to the platen roller and media advance mechanism.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product category | Printhead |
The printhead is rated at 203 dots per inch, which is the native resolution for the H-4212 thermal barcode label printer.
It is designed as a direct replacement for the Datamax H-4212 203dpi model, matching the original mounting points and ribbon cable connector.
Power off the printer, release the printhead latch, swap the unit, reseat the ribbon cable fully, close the latch, then run a calibration print to align the new head.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?