Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
300 dpi thermal printhead for Datamax H-4310 and A-4310 MarkII printers, part PHD20-2241-01
This new compatible printhead carries part number PHD20-2241-01 and is built for the Datamax H-4310 and A-4310 MarkII thermal label printers. It restores 300dpi output when the original head wears out. The package contains one thermal printhead ready for installation.
The head uses direct thermal technology so no ink, toner or ribbon is required during normal printing. Power draw stays low because only the heated elements activate for each label. Acoustic output is minimal with no moving print mechanism beyond the media feed.
Under continuous roll-fed workloads the head maintains consistent dot density across thousands of labels. Thermal cycling is managed by the printer firmware to prevent overheating during long print runs. It is not suited for applications needing colour or resolutions above 300dpi.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product category | Printhead |
Power off the printer, open the printhead latch, remove the old head, seat the new PHD20-2241-01 firmly until it clicks, close the latch, then run the printer's calibration routine; skipping calibration after latch closure is the step that causes misaligned labels.
Clean the printhead with isopropyl alcohol and a lint-free swab every roll change or when print quality fades; the head itself is a consumable and will eventually require full replacement once heating elements degrade.
The 300dpi thermal elements heat continuously during long runs; thermal throttling or element fatigue will reduce print density before mechanical wear becomes an issue.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?