DBTLAP 7010M12B ND1 70x70x10mm 12V 0.25A 2-pin laptop cooling fan
A 70 × 70 × 10 mm, 12 V, 0.25 A, 2-pin ball-bearing fan tested before shipping for direct laptop replacement
- Accessory categoryCooler
- Slim 10 mm profile fits tight laptop chassis
- 12 V .25 A draw keeps power use low
- 70 mm square frame matches original mounting points
- 2-pin connector enables direct motherboard hookup
- Tested before shipping ensures reliable operation
Replacement fan for 7010M12B ND1
This 70 mm by 10 mm slim fan is built to replace the original cooler in compatible laptops. It runs on 12 V and draws 0.25 A through a two-pin connector. The unit is new and tested before dispatch. Buyers who need a different voltage, pin layout or frame thickness cannot use this part.
Ball-bearing construction and two-pin power
A ball-bearing motor reduces friction for longer service life in a thin profile. The two-pin lead supplies power only, so speed reporting or PWM control is not available. Mounting holes match the 70 mm square footprint. Builders who require a three-pin or four-pin header should look elsewhere.
12 V 0.25 A rating decides fit
The electrical rating of 12 V at 0.25 A is the single figure that confirms compatibility with the target laptop. Verify the original fan carries the same voltage and current before ordering. Systems expecting a different amperage or voltage will not operate correctly with this cooler.
How it compares
Measured against everything we stock in Laptop Cooling Stands & Fans, at today’s prices. Recalculated every night.
- Price $12.99
- Cheaper than about 76% of the 6,169 comparable items (median $20.99).
Specifications
| Product | |
|---|---|
| Accessory category | Cooler |
Questions about this item
What voltage and current does the 2-pin connector supply to the 7010M12B ND1 fan?
The fan runs on 12 V and draws 0.25 A through its 2-pin connector.
What are the exact mounting dimensions for the 7010M12B ND1 cooler?
The unit measures 70 mm by 70 mm by 10 mm, so the mounting holes must match that 70 x 70 mm footprint.
How is the 7010M12B ND1 fan installed, and what step is often missed?
Remove the old fan, align the 2-pin plug with the motherboard header, secure the 70 x 70 mm frame with screws, then verify the connector is fully seated — partial insertion is the common mistake.
More in Laptop Cooling Stands & Fans
Similar items
Thermaltake CL-W098-CA00SL-A G1/4 PETG 45-Deg Dual Compression 16mm OD Fitting
DELL MGK85 laptop lid cover 17" blue for Inspiron 17R N7110
- Skin / Cover
- SWITCH by Design St…
LUOM N3 Adjustable Aluminum Laptop Stand Silver
- Stand
- Support up to 15.6-…
LUOM N3 laptop cooling pad Black 15.6 in 0.6 lbs
- Holder
- Support up to 15.6-…





