DBTLAP KSB0505HB -AJ1J DC05V 0.50A 4PIN replacement fan
A 5 V, 0.50 A four-pin replacement fan tested before shipping for Delta cooling assemblies
- Accessory categoryCooler
- Direct replacement for DELTA KSB0505HB-AJ1J fan
- 5 V DC and 0.50 A power draw matches original spec
- Four-pin connector ensures correct motherboard control
- Single tested unit ships ready for installation
- Verify part number and photos for 100% compatibility
Replacement Fan for Delta Cooling
This DBTLAP fan replaces the Delta KSB0505HB-AJ1J unit in compatible laptop cooling pads. It runs on DC 5 V and draws 0.50 A through a four-pin connector. The part is new and tested before shipping.
Upgrading from a Failed Original
The swap is worthwhile when the original Delta fan becomes noisy, spins slowly or stops entirely. Matching the exact part number restores the cooling performance the pad was designed to deliver without modifying the host device.
Straightforward Drop-In Installation
Remove the old fan, connect the four-pin plug and secure the replacement in the same mounting points. The main risk is ordering a visually similar but electrically different model; verify the KSB0505HB-AJ1J marking on your existing fan before purchasing.
How it compares
Measured against everything we stock in Laptop Cooling Stands & Fans, at today’s prices. Recalculated every night.
- Price $18.99
- Cheaper than about 55% of the 6,169 comparable items (median $20.99).
Specifications
| Product | |
|---|---|
| Accessory category | Cooler |
Questions about this item
Will the 4-pin connector on this KSB0505HB fan match my laptop's motherboard header?
The fan uses a 4-pin connector rated for DC 5 V and 0.50 A; verify your original fan carries the same part number and pin layout before ordering.
Which step do people skip when swapping this DELTA cooling fan into a laptop?
Many forget to peel the protective film off the thermal pad surface and to route the cable clear of the heatsink screws before tightening the assembly.
What part of this replacement fan typically wears out first after extended use?
The sleeve bearing inside the motor is the usual wear point; expect increased noise or reduced speed after long service intervals.
More in Laptop Cooling Stands & Fans
Similar items
OEM Industries T&T 6010L05F 569 60mm 5V .35A 3-pin cooling fan
- 60 mm
- Fans
DELL MGK85 laptop lid cover 17" blue for Inspiron 17R N7110
- Skin / Cover
- SWITCH by Design St…
VestTech PE827P3D1717GKL Laptop Cooling Pad
- 7 in (17.8 cm)
- 8.26 in × 4.33 in ×…
Fesjoy 7" USB 2.0 Dual-Fan Laptop Cooling Pad Black
- 7 in (17.8 cm)
- 20'





