Atdec TH-WH-PJ-CM projector ceiling mount
- Projector Mounts
- Material: Steel, Fl…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Genuine OEM DMD/DLP replacement chip restores clear projection for Philips HDP1690 and Pico Genie M550, M400, M1000 models
This genuine OEM DMD chip is a replacement component for Philips HDP1690 and Pico Genie M550, M400 and M1000 projectors. It restores the imaging engine so the projector can produce a clear picture again. The part is supplied new and has been extensively tested at least three times to confirm zero dead pixels. It is intended for owners of those specific models who need to replace a faulty imager.
The chip itself is a solid-state micro-mirror array with no moving parts and no integrated cooling. It draws negligible power from the projector's main board and adds no audible noise to the system. Thermal management is handled entirely by the projector's existing heat-sink and fan assembly. No additional power connectors or airflow considerations are required for this component.
This component fits only the Philips HDP1690, Pico Genie M550, M400 and M1000 projectors listed in the title. It will not work in any other DLP projector, even from the same brand, because the mirror array geometry and flex-cable pinout are model-specific. Buyers who own a different projector model cannot use this chip. Verify the exact model number on the unit before ordering.
Measured against everything we stock in Projector Mounts & Add-Ons, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | Others |
Remove the optical engine, disconnect the flex cable, swap the DMD chip, then re-seat the flex cable firmly — the step most people miss is locking the zero-insertion-force connector latch before reassembly.
No scheduled maintenance is required for the chip itself; keep the projector air filters clean to prevent dust from settling on the DMD surface and degrading image quality.
The primary limit under sustained operation is thermal — if the projector cooling system cannot dissipate heat, the DMD may overheat, causing temporary image artefacts or permanent pixel damage.
More in Projector Mounts & Add-Ons
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?