DELL Inspiron 5565 5567 15.6" Touchscreen LCD Video Ribbon Cable D8C2T
Genuine Dell OEM 15.6" touchscreen LCD video ribbon cable with IR camera support for Inspiron 5565 and 5567 models
- Product typeLaptop-computer-replacement-parts
- Genuine Dell OEM part ensures reliable touchscreen video signal
- Fits Inspiron 5565 and 5567 models with touchscreen and IR camera
- 6 inch cable matches original Dell part number D8C2T
- Replaces BAL20_EDP_CABLE_TS_IR and DC02002GZ00 for exact compatibility
- New condition guarantees a pristine replacement for damaged ribbon cables
Genuine Dell OEM replacement cable
This genuine Dell OEM ribbon cable carries the video signal to the 15.6 inch touchscreen on Inspiron 5565 and 5567 models equipped with an IR camera. It matches Dell part number D8C2T and the alternate numbers listed by the manufacturer. The part is supplied new and exactly as pictured.
Replaces a damaged or faulty original
Install this cable when the existing ribbon has failed due to hinge stress, cracking or connector wear. The jump is worth it when touch input, IR camera function or the display itself becomes unreliable. No other laptop models are supported by this specific part number.
Maintains signal integrity under daily flex
The ribbon is built to the same specification as the factory cable, so it sustains repeated lid open and close cycles without signal degradation. It restores stable video and touch performance for the life of the repair.
How it compares
Measured against everything we stock in VGA Monitor Cables, at today’s prices. Recalculated every night.
- Price $10.99
- Typical for this category: the median of 1,119 items is $10.99.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Product | |
|---|---|
| Brand name | Dell |
| Product type | Laptop-computer-replacement-parts |
Questions about this item
Does this D8C2T ribbon cable fit the 15.6 inch touchscreen panel on a Dell Inspiron 5565?
Yes, it is a genuine Dell OEM video ribbon cable made for the 15.6 inch touchscreen LCD with IR camera on Inspiron 5565 and 5567 models.
What connector orientation should I check before routing the cable through the hinge?
Align the eDP connector and IR camera flex exactly as shown in the product photo; forcing the ribbon the wrong way creases the traces and kills the touchscreen signal.
When should I replace this cable again after installation?
Only if the display develops flicker, dead touch zones, or the IR camera stops working — the ribbon itself has no scheduled service interval.
More in VGA Monitor Cables
Similar items
AddOn VGASPLMFF VGA male to 2x female splitter black 1920x1200
- Consumer Electronics
- Black
AAAwave PCIe 6-pin to dual 6+2-pin braided splitter cable 23 cm pack of 2
4XEM 4X35MF15 svga cable 15 ft 3.5 mm male to female
- Cable
- Black





