BIQU Panda Jet Pack V2.0 Transparent Shell 3D Printer Accessory
- Panda Jet Pack V2 T…
- US7-1060000840
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Semi-flexible TPU filament on a 500 g spool, 1.75 mm diameter, prints at 220–240 °C with high abrasion resistance and vivid orange colour
E3D spoolWorks FleXD is a 1.75 mm semi-flexible TPU filament supplied on a 500 g spool in Sweet Orange. It prints at 220-240 °C with a bed at 45-85 °C and delivers high shear strength plus high abrasion resistance. The material stays elastic and flexible while producing rich, solid colour.
This filament suits users printing phone cases, keyboard protectors, insoles or flexible vases and benchys that must survive repeated bending and impact. It adheres well with a glue stick and works with water-soluble scaffold support for clean overhangs. Builders who require rigid structural parts or very high-speed printing should consider other materials.
The manufacturer specifies a print speed of 30 % (15 mm/s) to maintain consistent flow and layer adhesion with this flexible formulation. Running faster typically causes under-extrusion or jamming, so the 15 mm/s figure is the practical limit for successful prints. Adjust temperature within the 220-240 °C range to fine-tune results for your specific printer.
Measured against everything we stock in 3D Printing Accessories & Materials, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | E3D |
| Model name | FleXD |
| Product color | Orange |
| Product type | Filament |
Mount the 500g spool, set the hotend to 220-240°C and the bed to 45-85°C, apply a glue stick for adhesion, and print at 15mm/s; the step most users miss is slowing the speed to 30% so the flexible filament does not buckle in the extruder.
Store the spool in a sealed bag with desiccant to stop moisture absorption; if the filament becomes brittle or hisses during printing, dry it at low heat before use, otherwise no scheduled replacement is required.
The 15mm/s feed rate is the first bottleneck; pushing beyond it causes under-extrusion and jams because the elastic material cannot be pushed faster through the hotend.
More in 3D Printing Accessories & Materials
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?