RCA VHB6111N 100 ft RG-6 coaxial rf cable black
- Digital RG6 Coaxial…
- Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Ten-foot low-loss coaxial cable with 50-ohm impedance and male BNC connectors for UHF wireless microphone systems
The Electro-Voice RE3-ACC-CXU10 is a 10-foot coaxial cable built for 50-ohm RF signal paths. It uses ultra-low-loss construction and robust male BNC connectors on each end. The cable is designed for UHF wireless microphone systems and antenna distribution runs. Condition is new.
Installers extending antennas from receivers or distribution amplifiers will find the impedance match and low attenuation useful. The 10-foot length fits typical rack-to-antenna distances. Buyers needing a different impedance, a different connector format, or a longer run for the same loss budget should look at other cables.
The defining specification is the 50-ohm characteristic impedance paired with male BNC terminations. This combination determines compatibility with UHF wireless receivers, distribution amplifiers, and antenna systems built for the same impedance. Verify that the connected equipment specifies 50-ohm BNC before purchasing.
Measured against everything we stock in Coaxial RF & Antenna Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Connect the robust male BNC connectors to the antenna and receiver, then hand-tighten each coupling until the bayonet pins lock; the common error is leaving the connector a quarter-turn loose, which raises loss on the 50 ohm line.
Inspect the BNC pins and dielectric for corrosion or kinks after each touring season; replace the 10' assembly if the centre conductor shows pitting or the jacket cracks, because the ultra-low-loss design cannot be repaired in the field.
The 10-foot length and 50 ohm impedance set the attenuation floor; under continuous high-power UHF transmission the dielectric temperature rise becomes the first limit, increasing insertion loss before the connectors or jacket degrade.
More in Coaxial RF & Antenna Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?