Lian Li UNI Fan TL LCD Wireless 140mm Reverse Blade case fan 14RTLLCD1W1B
- 140 mm
- Fluid Dynamic
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 12-inch black sleeved cable splits one 3-pin header into two fan connectors for extra cooling
This EN-Labs cable splits one motherboard 3-pin header into two 3-pin connectors so you can run a pair of case fans from a single fan header. It supports both 12 V and 5 V fans and accepts 4-pin PWM fans, though the PWM speed-control function is not passed through. The 12-inch length gives enough reach for typical chassis layouts without excess slack. Builders who need more than two fans on one header will need a different solution.
The cable uses 26 AWG copper conductors wrapped in a black net-jacket sleeve that resists abrasion and keeps the wiring tidy behind the motherboard tray. A single 3-pin TX3 female connector plugs into the board or a PSU adapter, while two 3-pin TX3 male ends attach to the fans. The sleeve adds a clean look and helps prevent snagging on sharp case edges during assembly.
The package contains only the splitter cable itself; there are no mounting clips, Velcro ties or configuration utilities supplied. Installation is purely plug-and-play, so no driver or firmware steps are required. Users who want cable-management hardware will need to source it separately.
Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | En-Labs |
| Model name | 3PINSPL212 |
| Product type | Cable Splitters |
| Product color | Black |
| Ports & slots | |
| Connector count | 3 |
| Connector gender | Female to Male |
| Size & build | |
| Overall length | 11 in - 15 in |
The cable is described as a PWM fan power cable, but the note states it works with 4-pin PWM fans with no PWM function, so the 3-pin TX3 connectors pass power only and do not carry a PWM signal.
The splitter uses 22AWG copper conductors wrapped in a black net-jacket sleeve and is 12 inches long, so allow enough space for the sleeve diameter and the full cable length when routing between the motherboard header and the two fans.
Plug the one 3-pin TX3 female connector onto the motherboard fan header or a 3-pin male lead from the power supply, then connect each 3-pin TX3 male connector to a fan; the step often missed is ensuring the female end is fully seated on the header before powering on.
More in PC Cooling Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?