Enfain OM3 LC-ST Duplex Multimode Fibre Optic Cable Aqua Blue 10m
OM3 duplex multimode patch cord with LC and ST connectors, 10 m aqua jacket, 3.0 mm diameter, 850 nm wavelength, .2 dB typical insertion loss, >38 dB return loss, 330 mm bend radius.
- OM3 core supports 10-gigabit multimode transmission at 850nm wavelength
- Low 0.2dB typical insertion loss preserves signal strength over 10m
- High >38dB return loss minimises back-reflection in duplex LC-ST links
- 0mm PVC jacket with 330mm bend radius eases routing in tight racks
- Rated for 1000 mating cycles from -20°C to +60°C operating range
OM3 duplex patch cable for 10 Gb links
This OM3 multimode fibre patch cable is built for 10 Gb Ethernet and compatible 1 Gb, 10 Gb and 40 Gb links in data-centre, server and switch environments. The duplex LC to ST connectors use ceramic ferrules and a 3.0 mm PVC jacket. It is a ready-to-install link for short-reach multimode runs.
Suits installers needing LC-to-ST connectivity
The cable matches equipment with LC and ST ports operating at 850 nm and supports the 10 Gb OM3 core specification. It is not suited for single-mode infrastructure, for links requiring SC, MPO or other connector types, or for wavelengths outside the 850 nm multimode window.
Fits standard patch panels with 330 mm bend radius
The 3.0 mm jacket allows routing in dense panels while the 330 mm minimum bend radius protects the OM3 core during installation. Typical insertion loss is 0.2 dB and maximum 0.3 dB, with return loss greater than 38 dB. Rated for 1000 mating cycles and an operating range of -20 °C to +60 °C.
How it compares
Measured against everything we stock in Fiber Optic Patch Cables, at today’s prices. Recalculated every night.
- Price $26.99
- Cheaper than about 54% of the 808 comparable items (median $29.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Other versions of this model
5 more in the same range
Questions about this item
Do I need existing LC and ST ports on my switch or server for this duplex cable to connect?
Yes, one end terminates in an LC connector and the other in an ST connector, so both corresponding ports must be present on the linked equipment.
Will the 3.0 mm jacket and 330 mm bend radius allow routing through the same trays as my older OM1 cables?
The 3.0 mm diameter and 330 mm minimum bend radius are compatible with standard tray spacing used for legacy multimode cables.
How can I verify the link is performing to spec after installation?
Measure insertion loss at 850 nm; a reading at or below 0.3 dB and return loss above 38 dB confirms the cable meets its rated performance.
More in Fiber Optic Patch Cables
Similar items
Black Box Corporation EFN6021-002M fibre optic cable OM2 50-micron LC-SC orange 2m
- Fiber Optic Cables
- Orange
Black Box Corporation EFN110-003M-STLC fibre optic cable 3 m
- Consumer Electronics
Black Box Corporation EFN310-002M-LCLC Single-Mode 9-Micron Duplex Fibre Optic Cable LC-LC PVC 2-m 6.5-ft
- Others
- Yellow
Total Micro Technologies MD463LL/A-TM fibre optic cable Thunderbolt 1 Gbit/s
- Consumer Electronics
Mellanox Technologies MCP1600-C003E26N 100GbE QSFP28 3m 26AWG fibre optic cable
- 1 x QSFP28 Network
- Fiber Optic
Cables To Go 28950 fibre optic cable LC-SC 9/125 duplex single-mode PVC yellow 16.4 ft 5 m
- Cable Connectors
- Yellow










