Tripp Lite U026-016 USB 2.0 Active Extension Cable 16 ft
- USB A to USB A
- USB 2.0
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Internal USB 2.0 header splitter turns one 9-pin motherboard connector into two female ports with a 30 cm shielded cable and adhesive backing
The ETopSell 9 Pin 2 in 1 Internal USB Splitter Cable turns one motherboard USB 2.0 header into two female ports. It suits builders who need extra internal connections for DIY light bars, PWM fans or other 9-pin USB 2.0 devices. The 30 cm length fits typical chassis layouts. A 3M adhesive strip on the back secures the PCB to the motherboard or case.
Wire-belt shielding and a short-circuit-prevention outlet design protect the header pins from accidental shorts. The splitter draws power directly from the motherboard header; total current for both downstream devices must not exceed the header's supply capability. Standard USB 2.0 headers deliver up to 500 mA, so plan device loads accordingly. No active cooling or fan noise is involved.
This adapter replaces the need for a second USB header on the motherboard when only one is free. It is not for builders who need more than two ports or who require USB 3.0 or higher speeds. The jump is worth it when a single 9-pin header must serve two 2.0 devices such as a front-panel hub and a fan controller.
Measured against everything we stock in USB Cords & Extension Cables, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Align the male connector with the header, press straight down, then press the 3M automotive adhesive tape on the cable back against the board or chassis to lock it in place; the short-circuit prevention outlet keeps pins from bridging if the cable is tugged.
Verify that the combined draw of both attached devices stays within the motherboard header’s 500 mA limit; if total current exceeds that, unplug the higher-drain device or use a powered hub instead.
The first limit is the 500 mA supply from the motherboard header; once the two ports together try to pull more than that, voltage drops and devices disconnect or fail to enumerate.
More in USB Cords & Extension Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?