Tripp Lite U026-016 USB 2.0 Active Extension Cable 16 ft
- USB A to USB A
- USB 2.0
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts a USB 2.0 Type-A male port to a 9/10-pin motherboard header with 480 Mbps data transfer and a 20 cm braided sleeve
This 20cm cable converts an external USB 2.0 Type-A male port into a 9-pin or 10-pin internal motherboard header. It suits builders adding a front-panel USB port or connecting internal devices like card readers and Bluetooth modules directly to the board header. The woven braid sleeve protects the conductors during routing inside the chassis.
The link operates at the USB 2.0 specification of 480Mbps, maintaining that rate across the full 20cm length without the signal drop-off seen in longer, unshielded jumpers. Power and data travel together on the active Pin6-Pin10 circuit, so connected peripherals receive both supplies reliably during continuous file transfers or device charging sessions.
It upgrades from bare crimp-pin cables that snag on components and lack strain relief, eliminating the need to hand-assemble a header plug. The jump is worth it when a single internal USB 2.0 device must be added and the board header is free, but it does not serve builds needing two active ports from one header because only the Pin6-Pin10 side carries signals.
Measured against everything we stock in USB Cords & Extension Cables, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Fervit |
The passive 20 cm cable produces no heat and no noise because it has no active components.
Your motherboard needs a standard USB 2.0 9-pin or 10-pin header with pins 6 to 10 wired, because only that side carries the signal.
Yes, the connector fits both 9-pin and 10-pin headers, but only the pin 6 to 10 section is active on either layout.
More in USB Cords & Extension Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?