Apple MD565LL/A 60W MagSafe 2 Power Adapter
- AC Power
- 60 W, Input: 100-24…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 600W DC-DC boost converter steps 10-60V input up to an adjustable 12-80V output with constant voltage and current control
The GCON DC-DC Boost Converter is a 600W high-power step-up module that accepts a wide input range of 10V to 60V and delivers an adjustable output of 12V to 80V. It features integrated constant voltage and constant current functions in a non-isolated topology, with the radiator and booster plate combined into a single unit for direct mounting.
Before ordering, verify that your source can supply a stable input voltage within the 10V to 60V window and that it will not sag below 10V under load, as low-voltage drops can damage the power devices. The module must be powered on before the load is connected, and multiple units cannot be paralleled on either the input or output side.
The integrated radiator uses a 5mm base plate with 21mm fin height across an 85mm by 63mm footprint to dissipate heat from the booster plate mounted directly above it. No fan is included, so cooling relies on natural convection and the mounting surface; audible noise is limited to coil behaviour under load, and the unit draws up to 600W from the source depending on the configured output voltage and current.
Measured against everything we stock in Other Adapters & Couplers, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The module arrives as an assembled board with integrated heatsink measuring 85 mm by 63 mm; you must supply your own DC power source within the 10 V to 60 V input range, wiring, and mounting hardware.
Choose an input source that stays between 10 V and 60 V, then set the output voltage anywhere from 12 V to 80 V to match your load; the converter only boosts, so output must be higher than input.
It indicates the maximum continuous power the board can deliver when input voltage, output voltage, and cooling allow; actual usable power depends on the specific input-output combination and thermal conditions.
More in Other Adapters & Couplers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?