Apple MD565LL/A 60W MagSafe 2 Power Adapter
- AC Power
- 60 W, Input: 100-24…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts M.2 NVMe to U.2 SFF-8639 with PCIe 5.0, 3.3V hot-plug power and protection circuits
This adapter converts an M.2 NVMe drive to a U.2 SFF-8639 interface using a pin-out defined by SFF-9402 Rev 1.1. It targets system integrators and technicians who need to install M.2 storage into enterprise backplanes or test equipment that only accept the 2.5-inch form factor. The card is designed and manufactured in Taiwan.
The decisive specification is the integrated PWM synchronous buck converter that steps 12V input down to a regulated 3.3V rail for the M.2 device. A NexFET power MOSFET with 32m ohm resistance and reverse-current protection enables hot-plug insertion while a programmable inrush slew-rate limits surge current to a maximum continuous 6.5A.
Continuous operation is guarded by output overcurrent protection, undervoltage lock-out monitoring and thermal shutdown circuitry. The 12V input rail carries a 5A fuse, a 5A Schottky barrier rectifier and a 400W bidirectional TVS diode to absorb transients. Output discharge control and over/under voltage protection maintain rail stability during prolonged heavy I/O.
Measured against everything we stock in Other Adapters & Couplers, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Adapter type | PCIe Gen5 |
It allows the M.2 NVMe drive to communicate at Gen5 speeds through the SFF-8639 connector, limited by the host controller and drive capabilities.
The built-in SFF-8639 connector follows the SFF-9402 Rev 1.1 pin-out, enabling a direct M.2 NVMe to U.2 conversion with proper signal mapping.
It requires a 12 V input rail protected by a 5 A fuse and 400 W bidirectional TVS, plus space for the onboard PWM buck converter, hot-swap controller, LEDs and 64 KB SMBUS EEPROM.
More in Other Adapters & Couplers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?