Apple MD565LL/A 60W MagSafe 2 Power Adapter
- AC Power
- 60 W, Input: 100-24…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts a 22x80mm M.2 NVMe SSD to a U.3 (SFF-8639) PCIe Gen4 interface with built-in 12V-to-3.3V power conversion and protection
This PCIe Gen4 adapter converts a U.3 (SFF-8639) bay to accept a 22x80mm M.2 NVMe SSD. It includes a built-in SFF-8639 connector with pin-out defined by SFF-9402 Rev1.1 and a PWM 12V-to-3.3V synchronous buck converter supplying up to 5.5A. Protection features cover overcurrent, undervoltage, over/under voltage, thermal shutdown and 500V HBM ESD. The board is designed and made in Taiwan.
It supports M.2 3.3V and 1.8V supply rails plus VIO_CFG, PERST#, CLKREQ# and WAKE# signal translation between 3.3V and 1.8V levels. Hot-plug power uses an eFuse with programmable 6.5A current limit and inrush slew-rate control. A 400W TVS diode protects the 3.3V input and the output stage uses a 32mΩ NexFET with Schottky rectifier. Builders whose backplane cannot deliver 12V to the converter or who need a different M.2 form factor should look elsewhere.
The adapter runs at Gen 4 16GT/s across the U.3 link, so the host must provide a PCIe Gen4 U.3 connection for full bandwidth. M.2 PERST# and PWRDIS signals are passed through from the U.3 pins. No other interface speed or protocol is supported by this board.
Measured against everything we stock in Other Adapters & Couplers, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Adapter type | PCIe Gen4 |
Plug the M.2 22x80mm NVMe SSD into the onboard slot, secure it with the screw, then insert the SFF-8639 end into the U.3 backplane; the step often missed is connecting the PERST# and CLKREQ# signal translators so the drive negotiates 3.3 V and 1.8 V levels correctly.
The PWM buck converter and eFuse are rated for continuous 5.5 A output with 6.5 A programmable limit; under normal loads no user-serviceable parts wear out, but if the thermal shutdown triggers repeatedly the MOSFET or TVS diode may need board-level replacement.
The 5.5 A maximum output current of the 12 V-to-3.3 V synchronous buck converter is the first hard ceiling; exceeding it trips the over-current protection and thermal shutdown before any signal-integrity limit is reached.
More in Other Adapters & Couplers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?