Total Micro Technologies W2F74AA-TM 150W power adapter
- Others
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pack of ten buck converters stepping 4.5–24 V down to selectable 5 V at up to 3 A with 97.5 % efficiency
The KEHIPI kit supplies ten identical step-down modules that accept DC 4.5-24V and deliver a regulated 5V rail at up to 3A. Each board measures 20 x 11 x 5 mm and uses 2.54 mm pitch solder pads for power and control connections. The synchronous design runs at 500KHz and achieves 97.5% efficiency at 6.5V to 5V, 0.7A.
Hobbyists powering microcontrollers, sensors or USB devices from 12V or 24V sources can solder a board directly onto a perf-board or header strip. The enable pin draws only 0.85mA quiescent current, so a permanent battery connection is practical. Builders who require adjustable output above 5V, reverse-polarity protection or over-voltage shutdown should select a different module.
The back-side jumpers let you choose 1.8V, 2.5V, 3.3V, 5V, 9V or 12V without any external components. At 12V in and 1.5A out no extra heatsink is needed; at full 3A load the temperature rises about 40°C, so forced air or a larger copper pour is advised. Short-circuit protection is present but not intended for continuous abuse.
Measured against everything we stock in AC Adapters & Power Bricks, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | AITRIP |
| Part number | EC1691660A |
The module accepts a DC input range of 4.5-24V, so any source within that window — such as a 12V battery or 24V supply — will work.
Yes, the welding-hole spacing is 2.54 mm, which is the standard pitch used on most perfboards and breadboards.
Measure the output with a multimeter; you should see the selected fixed voltage (1.8V, 2.5V, 3.3V, 5V, 9V or 12V) or your adjusted value between 0.8-17V, with ripple around 20 mV under load.
More in AC Adapters & Power Bricks
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?