Total Micro Technologies W2F74AA-TM 150W power adapter
- Others
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Five LM2596 step-down modules convert 4-40 V input to 1.25-37 V at up to 3 A with built-in voltmeter and protection
This pack supplies five identical LM2596 buck converters for bench work, hobby projects or small production runs. Each module accepts a 4-40V DC input and delivers a continuously adjustable 1.25-37V output. The built-in LED voltmeter shows either input or output voltage at the press of a button.
The regulator is rated for 2A continuous current and can reach 3A peak when adequate heatsinking is fitted. A 150kHz switching frequency keeps conversion losses low, but the supplier advises adding a heatsink once output current exceeds 2A or power goes above 15W. Input must remain at least 1.5V above the set output for stable regulation.
Reverse-connection, over-temperature and short-circuit safeguards protect both the module and connected loads. The display can be switched off with a long press to save power and remembers the last viewed voltage after power cycles. Calibration mode allows ±0.5V correction of the meter readings, stored permanently for each unit.
Measured against everything we stock in AC Adapters & Power Bricks, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | DROK |
The supplier recommends staying at 2A for optimal thermals and advises adding a heatsink whenever the output current exceeds 2A or the output power goes above 15W.
You must supply a DC source between 4V and 40V that is at least 1.5V higher than the desired output voltage.
Yes, the voltmeter activates once the input exceeds 4V, so a 5V source will power the display and let you monitor both input and output voltages.
More in AC Adapters & Power Bricks
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?