Total Micro Technologies W2F74AA-TM 150W power adapter
- Others
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pack of ten compact buck converters stepping 4.5-24V input down to adjustable 0.8-17V or fixed 1.8V, 2.5V, 3.3V, 5V, 9V, 12V at up to 3A
This pack supplies ten DROK buck converter modules that step DC 4.5-24V down to an adjustable 0.8-17V or to fixed outputs of 1.8V, 2.5V, 3.3V, 5V, 9V or 12V selectable on the board rear. Each module handles up to 3A with added cooling at full load, while 12V in at 1.5A out runs without extra cooling. The integrated enable pin stops operation at low level, and soldering pads on 2.54mm spacing suit breadboard or perfboard work.
The 4.5-24V input window means the modules cannot be fed from sources below 4.5V or above 24V, and the adjustable output stops at 17V. Peak efficiency reaches 97.5% at 6.5V to 5V and 0.7A, but at the full 3A the temperature rise hits 40°C, so sustained high-current use demands heatsinking or airflow. Operating temperature spans -40°C to +85°C, yet output power must be derated as temperature climbs.
At 1.5A from a 12V source the converters run cool enough for enclosed builds, while 3A is only practical with active cooling. Short-circuit protection is present but not designed for repeated faults, and there is no over-voltage or reverse-connection protection, so wiring mistakes can damage the module. The 0.85mA quiescent draw suits battery-powered projects, but builders needing isolated outputs or higher voltage steps will need a different topology.
Measured against everything we stock in AC Adapters & Power Bricks, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | DROK |
| Part number | FBA200407 2x |
| Size & build | |
| Product weight | 0.01 lb (0 kg) |
Use the fixed 1.8V, 2.5V, 3.3V, 5V, 9V or 12V settings by soldering the jumper on the rear; if your project needs a different voltage, leave the jumper off and turn the onboard potentiometer to dial in any value between 0.8V and 17V.
The module can deliver up to 3A, but at full load the temperature rises about 40°C, so add a heatsink or forced airflow; at lighter loads such as 1.5A from a 12V input no extra cooling is required.
Drive the enable pin high (2-5V) to run the converter, or pull it low (around 0V) to shut the output down; the pin defaults to enabled if left unconnected.
More in AC Adapters & Power Bricks
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?