Total Micro Technologies W2F74AA-TM 150W power adapter
- Others
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A DC buck converter with protective case and LCD screen steps 6–32 V input down to 1.25–32 V at up to 5 A and 75 W
This adjustable step-down module converts an input of 6-32V into a regulated output of 1.25-32V at up to 5A. The board uses an MP2304 chip rated for 75W peak power and 96% conversion efficiency. A built-in LCD shows voltage and current simultaneously, and a protective shell is included for bench use.
Makers prototyping battery chargers or LED drivers will appreciate the constant-current mode and calibration functions. Builders needing input reverse-polarity protection or sustained loads above 35W without extra heatsinking should look elsewhere, as the board lacks the former and requires enhanced cooling for the latter.
The single figure that decides fit is the maximum output power of 75W, provided the input stays at least 1.5V above the desired output. Above 35W or 3A the supplier recommends additional heat dissipation, so verify your thermal budget before committing.
Measured against everything we stock in AC Adapters & Power Bricks, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | DROK |
| Model name | F-MP2304 |
| Part number | FBA180080 2x |
| Size & build | |
| Product weight | 0.141 kg |
You need a DC source between 6 V and 32 V. The input must be at least 1.5 V higher than your desired output voltage.
Yes, the module accepts up to 32 V input, so a 12 V system is well within range. Keep wiring separate and add heatsinking if the load exceeds 35 W.
Power off, hold the SET key while powering on to enter calibration mode. Adjust with SET and ENT until the display matches a known reference, then wait two seconds for auto-save.
More in AC Adapters & Power Bricks
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?