Total Micro Technologies W2F74AA-TM 150W power adapter
- Others
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pack of two adjustable buck converters stepping 4-40V down to 1.25-37V at up to 3A with built-in voltmeter and protection
This pack supplies two adjustable DC-DC buck converters built around the LM2596 switching regulator. Each module accepts an input range of 4-40V and delivers a regulated output from 1.25-37V at up to 3A peak. An integrated LED voltmeter shows input or output voltage at the press of a button. Built-in protections guard against reverse polarity, overheating and short circuits.
Makers prototyping battery chargers, LED drivers or bench supplies will appreciate the dual display and calibration mode that stores offset corrections permanently. The potentiometer allows quick voltage trimming with a small screwdriver. Builders needing sustained loads above 2A or output power over 15W must add external heatsinking, and the 1.5V minimum headroom rule excludes very low-dropout applications.
The headline figure is the 3A maximum output current, rated for 2A continuous operation without extra cooling. This single limit determines whether the module can drive your intended load or if a higher-current regulator is required.
Measured against everything we stock in AC Adapters & Power Bricks, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | DROK |
The package contains five LED display LM2596 buck converters, not two. You will need a 4 V to 40 V DC power source, a mini screwdriver for the potentiometer, and a heatsink if you plan to draw more than 2 A or exceed 15 W output power.
There is only one version in the pack. Each module is rated for 2 A continuous current and can reach 3 A maximum; for best thermals stay at or below 2 A and add a heatsink if you go higher.
You can set the output anywhere between 1.25 V and 37 V provided the input is at least 1.5 V higher than your target voltage; the built-in voltmeter shows the actual output with ±0.1 V accuracy once input exceeds 4 V.
More in AC Adapters & Power Bricks
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?