Total Micro Technologies W2F74AA-TM 150W power adapter
- Others
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Five LM2596 step-down modules convert 3.0-40 V input to an adjustable 1.5-35 V output at up to 3 A each
The KEHIPI LM2596 pack contains five identical buck converters that accept a DC input between 3.0 V and 40 V and deliver an adjustable output from 1.5 V to 35 V. Each module is rated for a maximum output current of 3 A and uses SANYO solid-state capacitors on a 36 u thickened circuit board. An on-board LED indicates when the output is active. The units are supplied new and ready for integration into custom power circuits.
Every converter requires a source voltage at least 1.5 V above the desired output because the topology is step-down only. The blue potentiometer sets the output level; the factory defaults to a high voltage so roughly 15 to 20 counter-clockwise turns are needed before the voltage begins to fall. A multimeter is essential during this calibration. The compact 45 by 20 by 14 mm footprint leaves ample space on a protoboard or inside a small enclosure.
Under normal loads the LM2596 silicon runs warm but stays within its design limits without forced airflow. The high-Q inductance and solid-state capacitors keep ripple low and efficiency high across the adjustment range. No fan or heatsink is included, so sustained operation near the 3 A ceiling benefits from a modest copper pour or small clip-on heatsink. Quiescent draw is minimal, leaving most of the input power available to the load.
Measured against everything we stock in AC Adapters & Power Bricks, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | AITRIP |
| Model name | LM2596 |
| Part number | LM2596 |
| Product color | 5PCS |
| Size & build | |
| Product weight | 0.05 kg |
The input must be at least 1.5 V higher than the set output voltage; the module cannot boost.
The board uses high-Q inductance and solid-state capacitors rated for sustained loads; an LED indicator shows output status.
A DC power source within 3.0–40 V and a multimeter are required; adjust the blue potentiometer 15–20 turns counter-clockwise from the factory high setting.
More in AC Adapters & Power Bricks
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?