Clover Technologies Group, LLC CF064-67901-REF refurbished maintenance kit 225000 yield
- Printer Accessories
- Maintenance Kit
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
True Red PLA filament on a large spool, 1.75 mm diameter, tested at 100 and 200 micron resolutions for MakerBot Replicator 5th Generation Z18 printers
This MakerBot PLA filament is produced for the Replicator 5th Generation Z18 3D printer. It uses a bioplastic derived from corn and is guaranteed free of heavy metals, phthalates and BPA. The True Red colour comes on a spool weighing approximately 2 lb. It suits beginners and regular users who want consistent results on this platform.
Each colour is quality tested at both 100-micron and 200-micron layer resolutions on a Replicator 2 to verify reliable slicing and printing of every model type supported by MakerWare. The material adheres well to acrylic and blue painter's tape. Large bottom layers may curl, so rafts are recommended to prevent that behaviour.
The filament maintains steady flow during long print jobs rather than only in short bursts. Its formulation resists variation that can cause jams or layer shifts over many hours. This reliability supports continuous operation on the compatible Replicator 5th Generation Z18 machine.
Measured against everything we stock in Print & Scan Accessories, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product category | Other Accessories |
Preheat the nozzle, cut the tip cleanly, then feed the 1.75mm strand straight into the extruder until you feel resistance; the common error is pushing before the hot end reaches temperature, which grinds the PLA and clogs the drive gear.
The 2 lb spool lasts until the filament runs out or absorbs moisture; replace it when the printer starts under-extruding, the surface turns brittle, or you hear popping from steam bubbles during extrusion.
Warping at the base of large parts shows up before the spool empties; the supplier notes that prints with a large bottom layer tend to curl, so add a raft or use blue painter's tape to extend usable build time.
More in Print & Scan Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?