Total Micro Technologies W2F74AA-TM 150W power adapter
- Others
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Waterproof DC-DC step-down adapter converts 12V or 24V input to 5V USB-C output at up to 3A with 96% efficiency
This waterproof DC-DC converter steps 12 V or 24 V vehicle power down to a regulated 5 V output through a USB-C connector. It accepts an input range of 8 to 32 V and can deliver up to 3 A with a claimed peak efficiency of 96 %. Built-in overload, over-current, overheat and low-voltage protection helps keep connected devices safe.
Makers powering a Raspberry Pi 4 from a vehicle electrical system will appreciate the stable 5 V rail and USB-C plug. Drivers who want a compact, rugged way to charge phones or similar 5 V gear from a 12 V or 24 V supply also fit the target use case. Buyers needing more than 3 A, adjustable voltage, or a bare-board module without the waterproof housing should look at something else.
Verify that your source voltage stays within the 8 to 32 V window and that the load does not exceed 3 A. The supplied leads use 20 AWG wire, so confirm the gauge is adequate for your installation length and current. Ensure the USB-C port matches the charging or power input specification of the device you intend to connect.
Measured against everything we stock in AC Adapters & Power Bricks, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Adapter type | Power Converter |
Connect it to any DC source between 8 V and 32 V — a 12 V or 24 V vehicle battery is typical — and the module will deliver a steady 5 V output.
Yes, the adapter draws only what it needs up to 3 A at 5 V and includes overload, over-current, overheat and low-voltage protection so it won’t disrupt other 12 V loads.
Measure the output with a multimeter under load; you should read 5 V and the connected device (for example a Raspberry Pi 4) should boot and run stably at its rated current.
More in AC Adapters & Power Bricks
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?