Kingston Technology Corp. KSM56R46BD8PMI-48MBI 48GB DDR5-5600 CL46 2Rx8 Registered server RAM
- 48 GB
- DDR5 5600
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 16 GB DDR4 ECC registered kit with two 8 GB modules running at 2933 MHz and CL21 latency
This NEMIX RAM kit provides 16GB across two 8GB DDR4 2933MHz modules built to the PC4-23400 standard. Each stick is a 1Rx8 registered DIMM with ECC and operates at 1.2V. The kit targets servers that require registered error-correcting memory and is not intended for standard desktop computers.
Registered buffering places a register between the DRAM and the memory controller, adding one cycle of latency but reducing electrical load on the bus. This allows the memory subsystem to sustain the rated 2933MHz transfer rate across both modules during prolonged workloads without the signal degradation that can appear on unbuffered configurations. ECC correction runs continuously in the background, so sustained write and read streams maintain data integrity without pausing for software checks.
The 288-pin DDR4 form factor delivers the PC4-23400 data rate at 1.2V with CAS latency 21. Bandwidth is limited to the DDR4 2933 specification; systems that only support lower DDR4 speeds will downclock the modules accordingly. The registered design requires a memory controller that supports registered DIMMs, so platforms limited to unbuffered memory cannot use this kit.
Measured against everything we stock in ECC Server RAM, at today’s prices. Recalculated every night.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | NEMIX RAM |
| Model name | Part#: MR23400-818K2-SM-SYS-5019P-M |
| Part number | Part#: MR23400-818K2-SM-SYS-5019P-M |
| Total capacity | 16 GB (2 × 8 GB) |
| Performance | |
| Rated speed | DDR4 2933 (PC4 23400) |
| Processor | |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Memory | |
| CAS latency | 21 |
| ECC support | Yes |
| Buffer type | Registered |
| Memory rank | 1Rx8 |
| Power | |
| Rated voltage | 1.2 V |
The modules operate at the standard DDR4 voltage of 1.2V and a rated speed of 2933MHz, so power draw and heat output are in line with typical registered DIMMs at this frequency.
The board must provide DDR4 RDIMM slots that support ECC and registered memory; the kit uses the industry-standard 288-pin form factor and will not fit or function in UDIMM-only or non-ECC platforms.
Mixing 1Rx8 modules with DIMMs of another rank or speed forces the memory controller to run all channels at the lowest common frequency and may limit total capacity per channel; check your server vendor's qualified vendor list for supported population rules.
More in ECC Server RAM
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?