Lian Li UNI Fan TL LCD Wireless 140mm Reverse Blade case fan 14RTLLCD1W1B
- 140 mm
- Fluid Dynamic
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Sleeved 10-inch PWM splitter connects four case fans to one motherboard header using a single 4-pin tachometer line
This OIAGLH 1007 cable connects four case fans to a single motherboard fan header. One 4-pin female plug splits into four male connectors, one of which carries the RPM sense wire. The braided 10-inch length suits typical desktop builds.
Verify that your motherboard header can supply enough current for the combined draw of all attached fans. Only one of the four output connectors provides the tachometer signal, so the remaining three fans will not report speed to the BIOS. Ensure the 4-pin keying matches your header orientation.
The 24 AWG tinned-copper conductors and PVC insulation are rated to 80 °C, supporting continuous operation at typical case-fan currents. Voltage drop across the 10-inch run remains minimal, so all four fans maintain stable speeds under prolonged thermal load.
Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | Case Fan Accessory |
The pack contains two splitter cables. Each cable has a single 4-pin motherboard connector on one end and four fan connectors on the other — one 4-pin and three 3-pin. Plug each splitter into a motherboard header and attach up to four fans per cable; no additional cables are required.
Use the single 4-pin connector for the fan you want the motherboard to monitor by RPM; the three 3-pin connectors will still run PWM fans but without speed reporting.
Only the fan plugged into the 4-pin connector sends a tachometer signal back to the motherboard, so the BIOS will display and regulate speed based on that one fan while the other three follow the same PWM duty cycle.
More in PC Cooling Fans
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?