Battery Technology Inc. ET-LAD60W-BTI projector lamp 330 Watt 2000 Hrs
- 330 W
- 2,000 Hrs.
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement lamp module for PT-D6000S projectors with 300W UHM bulb and housing rated for 2,000 hours
The Panasonic PT-D6000S replacement lamp ships as a complete bulb-and-housing assembly rated at 300 W with a 2,000-hour service life. It is designed for technicians and AV managers who need a direct swap without additional assembly steps. The unit is manufactured to ISO 9001 quality standards and undergoes beam, ignition, voltage and run-time checks before dispatch.
At 300 W the lamp delivers the brightness expected from the original equipment while drawing the same power budget, so existing cooling and electrical circuits remain adequate. Normal operation follows the rated 2,000-hour window before a replacement cycle is due. No separate ballast or driver changes are required for installation.
The pre-assembled housing eliminates alignment tasks and reduces downtime during changeover. Each module is tested for beam performance, ignition reliability, voltage stability, cosmetic appearance and connector integrity. Buyers who require a bare bulb without housing or who need a different wattage rating will need a separate product.
Measured against everything we stock in Replacement Projector Bulbs, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | Projector Lamp |
| Display | |
| Lamp lifespan | 2,000 Hrs. |
| Power | |
| Power rating | 300 W |
Power off and unplug the projector, let it cool, remove the lamp cover, loosen the retaining screws, pull out the old module by its handle, slide the new housing in until it seats firmly, retighten the screws, replace the cover, then reset the lamp timer in the menu so the 2,000-hour counter starts from zero.
The lamp is rated for 2,000 hours of typical use; after that the bulb will dim and must be replaced with a new module. No user-serviceable parts exist inside the housing, and the projector’s air filters should be cleaned periodically to maintain airflow.
The 2,000-hour rated life is the primary limit; extended sessions also raise internal temperature, so the projector’s thermal protection may shut the unit down if ventilation is restricted or filters are clogged.
More in Replacement Projector Bulbs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?