RCA VHB6111N 100 ft RG-6 coaxial rf cable black
- Digital RG6 Coaxial…
- Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Two 12-inch 50 ohm PL-259 jumper cables with 17AWG RG8x conductors and 128-strand aluminum braid for low-loss RF links
This 1 ft coaxial cable connects CB radios, antenna analysers, tuners, switches, monitors, dummy loads and SWR meters using UHF PL-259 male plugs on both ends. The nickel-plated connectors are fully moulded for strain relief and consistent contact. It is also suited to Jeep Wrangler CB installations where a short, low-loss link is required.
The cable uses a 17 AWG pure copper centre conductor and a braid shield of 128 strands of 0.12 mm aluminium wire to achieve low attenuation at 50 ohms. RG8x is a step up from standard RG-58 coax and is recommended for higher-powered applications. The thicker conductor and dense shielding preserve signal integrity across the short jumper length.
Supplied as a 2-pack, the cables provide spare or parallel links for equipment that needs two coaxial paths such as a radio and an analyser simultaneously. Each 1 ft length limits reach to adjacent devices on a bench or in a vehicle console. Runs that exceed this distance or require a different connector type will need alternative cable assemblies.
Measured against everything we stock in Coaxial RF & Antenna Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | Other |
The listing supplies two 12-inch PL-259 jumpers in one pack. If your antenna analyser, SWR meter or dummy load sits closer than 12 inches, the cables will reach; otherwise you will need a longer pair.
The 50 ohm impedance matches standard CB and ham radio gear, so the RG8x jumper passes the signal without reflection when used with a 50 ohm antenna, analyser or meter.
Each end carries a UHF PL-259 male plug, so the cable only mates with PL-259 female ports — common on CB radios, antenna analysers, tuners, dummy loads and SWR meters.
More in Coaxial RF & Antenna Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?