PROJECTIONDESIGN F12 220W compatible projector lamp

Ready-to-install lamp module

This replacement lamp ships as a complete 220 W UHP bulb already seated in its housing so it drops straight into a Projectiondesign F12 projector without extra assembly. It is aimed at owners who need a new light source quickly and want to avoid aligning a bare bulb themselves. The module restores full brightness for home-cinema, classroom or boardroom use. No additional parts are required for the swap.

Plug-and-play fit for F12 projectors

Because the bulb and housing arrive pre-assembled, the installer only needs to open the projector's lamp door, remove the old module and insert this one. The design matches the original 400-0600-00 form factor so no mounting adapters or cable changes are involved. It frees the user from handling a fragile bare lamp and from reusing an old housing that may have warped. Installation time is reduced to a single step.

2 000-hour rated life at 220 W

The lamp is rated for 2 000 hours of operation at its nominal 220 W power draw, giving months of typical daily use before a dimming notice appears. Heavy users running the projector for many hours each day will reach the limit sooner and should plan a spare. The rating is a manufacturer estimate; actual life varies with ambient temperature, on-off cycles and selected brightness mode. When brightness drops below an acceptable level the module must be replaced.