Ruth's sister 24 Pin Switch Cable 18awg 50cm internal power cable
A 24-pin ATX power-switch cable with 18 AWG conductors and a 50 cm length for bench testing or mining rigs
- ATX 24-pin switch enables manual power control
- 18 AWG conductors handle high-current loads safely
- 50 cm length fits compact chassis layouts
- Synchronises dual PSU start-up for mining rigs
- Doubles as a power-supply tester for diagnostics
24-Pin ATX Switch Cable
This 24-pin ATX switch cable lets you start a power supply without a motherboard. It is built for bench testing, mining rigs or any setup that needs manual PSU control. The integrated switch replaces the usual paper-clip jumper for safer, repeatable power-on cycles.
18 AWG Wire and 50 cm Length
The cable uses 18 AWG conductors rated for standard ATX currents. Its 50 cm length reaches from a bench PSU to a test board or open-air mining frame without excess slack. Longer runs or permanent case routing would require a different cable.
Manual PSU Power Control
The single decisive spec is the built-in on/off switch on the 24-pin connector. If you need to power a supply independently of a motherboard, this cable does that job. If you need a standard extension or a sleeved cable for a case build, this is not the right part.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $41.99
- Pricier than about 79% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Should I choose the 18 AWG version or a thicker gauge for my ATX 24-pin setup?
This cable uses 18 AWG conductors, which are standard for ATX 24-pin power connections and suitable for typical system power draw.
What does the 50 cm length mean for cable routing inside my case?
The 50 cm length provides enough reach for most mid-tower builds while minimising excess cable that would need to be tucked away.
How does the 24-pin ATX interface with the integrated switch control power-on?
The 24-pin connector plugs into the motherboard or PSU tester, and the inline switch manually bridges the PS_ON signal to ground, turning the supply on or off.
More in Internal PSU & Riser Cables
Similar items
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





