Ruth's sister 500W ATX internal power cable
Delivers 500 W via a non-modular ATX design with Active PFC, 20+4-pin motherboard connector, four-pin CPU plug and two SATA ports
- 500 W output powers mid-range gaming desktops
- Active PFC improves efficiency and reduces electrical noise
- 20 + 4-pin ATX connector fits 20- and 24-pin motherboards
- Seven protection circuits guard against voltage and current faults
- Two SATA connectors support multiple storage drives
500W ATX power supply for desktop and server builds
This unit delivers 500 watts through a non‑modular 20+4 pin ATX connector and active power factor correction. It is intended for standard desktop and server chassis that accept a fixed cable layout. The input range of 170 to 264 volts suits typical mains supplies worldwide.
Two SATA ports and dual D‑type connectors limit
With only two SATA power outputs and two D‑type (Molex) connectors the supply can run a boot drive plus one extra drive or peripheral. Systems needing three or more SATA devices or a dedicated PCIe graphics power connector will exceed the available leads.
Non‑modular cabling and 12 cm fan shape daily
All cables are permanently attached, so unused leads must be routed inside the case. The built‑in 12 cm fan provides cooling while the baked black enclosure resists dust and insects. A 4‑pin CPU power connector supports compatible motherboards without adapters.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $61.99
- Pricier than about 86% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Will the 20+4-pin ATX connector fit my existing 20-pin motherboard?
The 20+4-pin interface is fully compatible with both 20-pin and 24-pin motherboards, so it will connect directly to your older board without an adapter.
How can I confirm the 12 cm fan is running correctly after installation?
Power on the system and listen for the fan spinning; the unit also includes overvoltage, undervoltage, overcurrent, overload and short-circuit protections that will shut it down if a fault occurs.
Which cables are permanently attached and what must I add for extra drives?
The non-modular unit comes with a fixed 20+4-pin ATX cable, a 4-pin CPU cable, two large peripheral connectors and two SATA connectors; additional SATA or peripheral cables cannot be added separately.
More in Internal PSU & Riser Cables
Similar items
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





