Ruth's sister Optical Endstop Switch 35mm x 15mm Red
Optical endstop switch measuring 35mm by 15mm in red plastic for 3D printer RAMPS 1.4 boards
- Optical sensing gives precise limit detection for 3D printers
- Red plastic housing measures 35 mm by 15 mm for compact mounting
- Designed to work with RAMPS 1.4 control boards
- Single unit supplied ready to install
- Brand-new condition ensures reliable operation from first use
Optical Endstop Switch for 3D Printers
This optical endstop switch is designed for 3D printers using a RAMPS 1.4 control board. It provides a light-control limit function to define axis boundaries during printing. The compact module suits hobbyists and builders who need a reliable positional sensor for a single printer upgrade or repair.
Simple Three-Wire Installation
The switch connects with three wires to the RAMPS 1.4 endstop headers, requiring no soldering if the board uses standard connectors. Builders should verify pin order against the board silkscreen because reversed polarity will prevent the sensor from triggering. The plastic housing is fragile, so avoid over-tightening mounting screws.
35mm x 15mm Form Factor
Measuring 35mm by 15mm, the unit fits tight carriage spaces where mechanical switches cannot. It handles standard Cartesian and delta printer homing routines with consistent repeatability. The optical design has no moving contacts to wear out, but dust or filament debris on the sensor window can interrupt the beam and cause missed triggers.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $9.99
- Cheaper than about 80% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
How do I verify the optical endstop triggers correctly after wiring it to my RAMPS 1.4 board?
Connect the three pins to the RAMPS 1.4 endstop header, power the printer, and watch the firmware status change when the light beam is interrupted by the printer axis.
What comes in the package and what extra parts are needed to install it?
The package contains one red optical endstop switch measuring 35mm x 15mm; you must supply the RAMPS 1.4 board and three-pin jumper wires yourself.
Which version should I choose for a standard RAMPS 1.4 setup?
This single red 35mm x 15mm optical endstop is the only version listed and is designed specifically for RAMPS 1.4 compatibility.
More in Internal PSU & Riser Cables
Similar items
Ruth's sister 25mm Large Diaphragm Cartridge Core Capsule internal power cable
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Ruth's sister USB-C Female to 4.0x1.7mm DC Adapter for Lenovo IdeaPad 310 110 100 internal power cable
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





