Ruth's sister RF 2-Way Power Splitter Module internal power cable
Splits one RF signal into two equal outputs across 100-2700 MHz with 20 dB isolation and 1 dB insertion loss
- Wide 100-2700 MHz frequency range for versatile RF applications
- Low 1.4 VSWR and 1 dB insertion loss preserve signal integrity
- High 20 dB isolation between output ports minimises crosstalk
- Handles up to 25 W input power for demanding industrial use
- Compact 53 x 47 x 7 mm PCB module fits tight enclosures
RF Power Splitter for Signal Distribution
This Ruth's sister module splits one RF input into two equal output channels across a 100-2700MHz frequency range. It handles up to 25W maximum input power with 50-ohm impedance matching. The microstrip design achieves 1.4 VSWR and 20dB isolation between ports for stable signal division.
Suits RF testing and combining applications
Engineers needing a passive power divider for bench testing or signal distribution will find the wide frequency coverage and low 1dB insertion loss practical. The module also functions as a combiner to merge two signals into one output. Buyers requiring higher power handling, different impedance values, or operation outside the 100-2700MHz band should look at alternative designs.
Compact PCB module for custom integration
Measuring approximately 53x47x7mm, the bare PCB construction fits inside enclosures or test fixtures without dedicated mounting hardware. The 0.3dB passband ripple and 3° phase imbalance support coherent signal splitting across the operating band. No DC power or control interface is needed; the passive network connects directly into the RF signal chain.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $13.99
- Cheaper than about 55% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
What RF equipment with 50 Ω connectors do I need to connect to the three SMA ports on this splitter?
You need a signal source and two loads or antennas, each fitted with 50 Ω SMA connectors, to use the 100-2700 MHz splitter as a divider or combiner.
Can I cascade this 1.4 VSWR splitter with older 50 Ω RF gear without degrading the 20 dB isolation spec?
Yes, the 50 Ω impedance match and 20 dB isolation are maintained when cascaded with other 50 Ω components across the 100-2700 MHz range.
How can I verify the splitter is performing to its 1 dB insertion loss and 3° phase imbalance ratings after installation?
Measure insertion loss and phase difference between the two output ports with a vector network analyser; readings should stay within 1 dB and 3° across 100-2700 MHz.
More in Internal PSU & Riser Cables
Similar items
STARTECH LP4PCIEX8ADP 6.1 in LP4 to 8 Pin PCIe Power Cable Adapter
- 6.1 in (15.5 cm)
- Cable Connectors
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Ruth's sister IDC50P 50 Pin Male Connector to Terminal Block Adapter
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





