Ruth's sister USB 5 Axis CNC Breakout Board internal power cable
Connects a USB 5-axis CNC breakout board to internal power for MACH3 drive board and stepper motor controller operation
- USB connectivity simplifies CNC controller setup
- Five-axis support enables complex machining operations
- MACH3 compatibility works with established CNC software
- Stepper motor driver control provides precise movement coordination
CNC breakout board with USB control
This USB 5-axis breakout board connects a PC running MACH3 to stepper motor drivers through a standard USB interface. It provides isolated signal routing for up to five axes, letting hobbyists and small-shop operators run a CNC mill, router or lathe from a modern computer without a legacy parallel port. The board acts as the motion-control interface between software and driver hardware.
Five-axis limit with single USB link
The adapter handles five axes simultaneously, which covers most 3-axis mills plus a rotary axis or dual-gantry setup. It does not support six or more axes, so machines needing additional spindles, tool changers or coordinated secondary tables will require a different motion controller. Bandwidth is limited to the USB 2.0 link, so extremely high pulse-rate applications may exceed reliable throughput.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $13.99
- Cheaper than about 55% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Will the USB interface on this breakout board work with the parallel-port CNC software I currently run on my older PC?
This board connects via USB and is designed for MACH3, so it replaces a parallel-port connection; your existing PC only needs a free USB port and MACH3 installed.
How can I confirm the board is communicating correctly with MACH3 after I wire the stepper drivers?
Open MACH3, enable the USB plugin, jog each axis and watch the DROs update — smooth movement and correct step counts show the board is working.
More in Internal PSU & Riser Cables
Similar items
STARTECH LP4PCIEX8ADP 6.1 in LP4 to 8 Pin PCIe Power Cable Adapter
- 6.1 in (15.5 cm)
- Cable Connectors
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Ruth's sister IDC50P 50 Pin Male Connector to Terminal Block Adapter
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…





